36 Installing and Activating TI Software
POINT_TO_LICENSE_SERVER
LICENSE_SERVER_1
LICENSE_SERVER_2
#Configuration item needed for deploying software using Apple Remote
Desktop and more specifically is a required parameter for Concurrent
client installations.
#Accepted values: YES/NO
POINT_TO_LICENSE_SERVER=NO
--------------------------------------------------
License type: Concurrent only
Comment: The Point_To_License_Server must be set to ’YES’ before
deployment.
#Configuration item that points the client software application to the
specified primary license server for license checkout.
#Accepted values: IP address or hostname.
LICENSE_SERVER_1=
--------------------------------------------------
License type: Concurrent only
Comment: It is recommended that you enter the hostname here with
License_Server_1 and use the IP address for License_Server_2. If you
have an additional server you can use License_Server_3.
#Configuration item that points the client application to the specified
secondary license server in case the primary license server is not available
or cannot be contacted.
#Accepted values: IP address or hostname.
LICENSE_SERVER_2=
--------------------------------------------------
License type: Concurrent only
Comment: It is recommended that you enter the IP address here with
License_Server_2 and use the hostname in License_Server_1. If you
have an additional server you can use License_Server_3.
To Next Page
Loading...
Need help?
General
