Using a Mouse
Although the TravelMate 4000M comes with a pointing device already
installed, you may use an external PS/2 or serial mouse.
1.
Turnoff the computer.
Note:
If you connect the PS/2 mouse to the computer while power is on,
press
Ctrl-Alt-Del
(warm start), or cycle power so the computer can detect
the presence of the mouse.
2.
Attach the six-pin Mini-Din connector to the mouse and insert the
other end of the connector into the left side of the TravelMate 4000M
or connect the serial mouse to the 9-pin serial port on the back of the
notebook. If desired, you may also use a serial infrared mouse.
3.
Set the keyboard/mouse switch located between the serial and parallel
port on the rear of the notebook to the down position.
4.
Reconnect the AC Adapter, and turn on the computer.
5-6
To Next Page
Loading...
