www.ti.com
Introduction
3
SNAU228–January 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
USB2ANY Interface Adapter
1.3 FCC Warning
This equipment is intended for use in a laboratory test environment only. The equipment generates, uses,
and can radiate radio frequency energy and has not been tested for compliance with the limits of
computing devices pursuant to subpart J of part 15 of FCC rules, which are designed to provide
reasonable protection against radio frequency interference. Operation of this equipment in other
environments may cause interference with radio communications, in which case, the user, at their own
expense, is required to take whatever measures may be required to correct this interference.
1.4 Description
The USB2ANY is a small dongle intended to allow a computer to control an electronic evaluation module
(EVM) via a USB connection. These EVMs cannot normally connect directly to the computer because of
their specialized interfaces, which are typically supported on commercial computers.
The USB2ANY is a USB 2.0 device supporting several different interfaces, including:
• 13 general purpose input/output (GPIO) (shared) lines with switchable pullup or pulldown resistors
• I
2
C with programmable 1.5-kΩ pullup resistors
• SPI – up to 8-MHz SCLK
• UART (300 to 230,400 Baud)
• Four analog inputs, 12-bit analog-to-digital converter (ADC)
• Two analog outputs, 8-bit digital-to-analog converter (DAC)
• Four PWM outputs
• Several other interfaces
• Switchable 3.3-V or 5-V power to DUT
The USB2ANY board can source regulated 3.3-V and 5.0-V DC power to the target device, up to a
maximum of 300 mA (combined 3.3 V and 5.0 V). The voltage outputs have built-in current sensing and
limiting circuits that protect both the EVM and the USB2ANY from overcurrent, shorts, and so forth.
The USB2ANY is shipped with a USB cable, a 10-pin cable (for most common interfaces), and a 30-pin
cable (for all supported interfaces).
Figure 1. USB2ANY and the Supplied Cables
To Next Page
Loading...
Need help?
General
