Connecting the USB2ANY
www.ti.com
8
SNAU228–January 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
USB2ANY Interface Adapter
3.1 Using the 10-Pin Cable
Figure 5. 10-pin Cable Connection
The 10-pin cable is connected to J4 as Figure 5 shows and can be used for most of the popular
interfaces, including:
• I2C: SDA and SCL
• SPI: SCLK, MOSI, MISO, and CS
• UART: RX and TX
• Power: 3.3-V external
• GPIO: GPIO0, GPIO1, GPIO2, GPIO3, GPIO4, GPIO5, GPIO6, and GPIO7
• PWM: PWM0, PWM1, and PWM2
• OneWire: OW1, OW2, and OW3
• µWire: SCLK, MOSI, MISO, and CS
• RFFE: SCLK and SDATA
3.2 Using the 30-Pin Cable
The 30-pin cable is connected across J3, J4, and J5 as Figure 6 shows, and can be used to access all of
the available interfaces signals (see Table 2 for a list of all the signals).
Figure 6. 30-Pin Cable Connection
To Next Page
