www.ti.com
Connecting the USB2ANY
9
SNAU228–January 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
USB2ANY Interface Adapter
3.3 Connecting the USB2ANY to the Computer
The USB2ANY has a USB Mini-B connector on the right side. Plug the provided USB cable (or any USB
cable with a Mini-B connector) into the USB2ANY. Plug the other end of the cable (USB ‘A’) into the
computer.
Figure 7. USB Connector
When connected, the LED on the USB2ANY should flicker quickly a few times, and then stay on.
3.4 Connecting the USB2ANY to an EVM
Depending on the EVM, choose either the 10-pin ribbon cable or the 30-pin ribbon cable. The majority of
EVMs use the 10-pin version, as Figure 8 shows.
Figure 8. Connection Between the USB2ANY and the EVM
To Next Page
Loading...