Texas 5135 TR/W - User Manual

Questions and Answers

E
Erica BrownAug 4, 2025
Why won't my Texas Lawn Mower start, even when pulling the cord or pushing the electric start button?
- B
  Barbara SimonAug 5, 2025
  There are several reasons why your Texas Lawn Mower might not be starting. Make sure you are activating the engine brake handle when starting. Check that the wires are correctly connected to the battery. The engine brake cable might need adjustment. Ensure the mower isn't standing in high grass. Prime the engine by pushing the primer 1-3 times. Verify the choke is in the correct position. Also, check the fuel tank to make sure it's not empty or that the gasoline isn't old (more than 3 months). If the gasoline is old, empty the tank and carburetor and refill with fresh gasoline.
J
Jennifer GarciaAug 8, 2025
How to fix no ignition spark on my Texas Lawn Mower?
- D
  David HaynesAug 8, 2025
  If there's no ignition spark, start by checking that the spark plug cap is firmly attached. Inspect the spark plug for dirt. Also, verify the correct gap between the spark plug and the electrode, adjusting it as needed or replacing the spark plug. Finally, examine the air filter for dirt and clean it if necessary.
M
Michael WadeAug 12, 2025
What to do if Texas 5135 TR/W Lawn Mower engine runs irregularly?
- R
  Raymond JonesAug 12, 2025
  If your Texas Lawn Mower engine is running irregularly, begin by checking that the spark plug cap is firmly attached. Ensure the spark plug is clean and undamaged. Inspect the gap between the spark plug and the electrode. Examine the air filter for dirt. If these steps don't resolve the issue, give the engine a few minutes to cool down, and then try restarting it. Also, check the throttle cable and tighten it if it's loose. As a last step, consider cleaning the carburetor if there's dirt in it.
A
Amber WellsAug 17, 2025
Why is the start cable so tight on my Texas 5135 TR/W Lawn Mower?
- A
  Andre JacksonAug 17, 2025
  If the start cable on your Texas Lawn Mower is very tight, make sure that you are activating the brake handle. If that doesn't work, the machine might be placed in high grass; move it to an area with less grass and set the height adjustment to the highest position.
J
James HigginsAug 21, 2025
Why does my Texas 5135 TR/W have insufficient engine revolutions?
- K
  Kathy CoxAug 21, 2025
  If your Texas Lawn Mower isn't revving high enough, check that the lever isn't in the "Choke" position; set it to "Run". Also, make sure the throttle lever isn't set to "Turtle"; set it to "Rabbit".
D
dawsonoscarAug 26, 2025
What to do if the back wheels of my Texas 5135 TR/W Lawn Mower are not pulling?
- J
  Jeffrey AguilarAug 26, 2025
  If the back wheels of your Texas Lawn Mower aren't pulling, the clutch cable may be too tight or too loose; adjust it. Also, the ratchets in the rear wheels might be worn, in which case you should replace them.
S
Stacy CruzAug 30, 2025
What to do if my Texas 5135 TR/W does not stop after 5 seconds?
- M
  Michael LuceroAug 30, 2025
  If your Texas Lawn Mower doesn't stop after 5 seconds, the engine brake cable might be running too tightly. In this case, you should check and adjust the engine brake cable.