3. Oil / changing oil
- Always check the oil level when the engine is placed in a horizontal position.
- Always check the oil level without fastening the oil stick.
- See fig. 2 pos 1, 2.
Oil should be changed in accordance with the user manual for the machine.
1. Let the engine run 5 minutes, so that the oil is heated. This makes the oil flow more
easily and it is easier to complete the oil change.
2. After 5 minutes the engine is turned off. Unscrew the engines oil drain screw and
the oil runs out of the engine. Remember to keep an appropriate container ready.
3. Put the drain screw back in its place and new oil is added to the engine.
4. You add oil by removing the oil stick and adding the correct amount of oil.
(TG485: 0.45L) (TG585: 0.6L)
See fig 2, Position 3 is the engines drain screw.
Alternatively use an oil drainage kit, Tex Parts : 40-11336
Remember to dispose the used oil so that it does no harm to nature.
Use your local recycling station.
4. Fuel
Only use unleaded octane 95 fuel on your engine and the right capacity.
Never overfill the tank with gasoline. Only fill to the lower edge of the filter.
See tank fig 1, pos 5.
To Next Page
Loading...
Need help?
General
