8. Operation
- Please draw attention to the following during operation.
- The exhaust must not be black. If this occurs the load is too high or the engine has
not been adjusted correctly.
- No incorrect noises and vibrations.
- If any of the above appears, turn off the engine and adjust it or contact your Power
Line dealer.
9. Spark plug
- Remove the sparking plug cover. (Caution, it may be hot, if the engine have been
running).
- Brush off dirt from the spark plug.
- Use a spark plug wrench to loosen the spark plug.
- Inspect if the isolation is intact.
- Clean the spark plug with a steel brush.
- Measure the electrode distance; make sure not to damage the electrode.
- The distance should be: 0,7 – 0,8 mm.
- If the sparking plug is okay, put it back in its place.
Otherwise replace using Denso type W16EPR-U.
- Put the sparking plug cover back in its place.
- See fig 1, pos 1.
To Next Page
Loading...
Need help?
General
