Texecom Premier Elite 12-W - Signalling Test

Engineer Utilities Premier Elite Series Installation Manual
140 INS176-15
Signalling Test
Enginee Uils
ie Een og
E o elec:
Enginee Uils
y

elec Zones
Zone  
y
elec eas 
<
elec Zones
Zone 
C
Enginee Uils
ignalling es
y
og  Enginee
and  yse
y
la Enginee
oing on ie
n

E o elec:
Zone ep
9

:373 e 
This new feature allows all of the communication paths available to
be tested to ensure that they are signalling correctly. During the test
sounders will be disabled, but signalling to ARC's or other devices
will occur allowing a system to be checked even in an occupied
building. This is similar to the current method of using the Engineer
Alarm attribute for zones, but is now a much simpler procedure as
the function is contained within one menu.
During the test only devices selected will cause an alarm activation.
Ricochet devices
The operation of Ricochet devices selected for the signalling test will
be altered for the duration of the test. With the exception of Ricochet
sounders all devices will be changed to Always Awake to make
testing easier. Once the test is complete and the system is disarmed
all devices will be put back to their originally programmed state.
Use the number keys to toggle Areas
On or Off
Use the  key or enter the Zone
number to select the zone required.
Use the C key to enable the zone in
the Signalling Test
A
*
will be shown on the screen
indicating the zone is selected and can
be used for the signalling test.
• Pressing n will arm the system
as an engineer. The engineer's
code can then used to disarm the
system following the test.
• If after a short time you do not
press y or n the system will
arm as an engineer and may be
disarmed with the engineer's code
following the test.
• Pressing y will log the engineer
off and arm the system as the
master user. The signalling test
WILL NOT be able to be
performed, and a user will then be
required to disarm the system
following the test.
Once the test is complete enter the
code required to disarm the system.
Any zones selected for the test will be
reinstated into the system.
Any Ricochet devices enabled for the
test will be returned to their
programmed mode of operation.
View Unique ID
This menu allows you to view the Unique ID assigned to the panel.
The ID is used by Texecom cloud based services. V4> panels have
the code by default. Panels flashed from earlier versions of firmware
will need to be connected to Wintex to have a Unique ID written to
them.