Premier Elite ComIP Installation Manual
8 INS273-6
• Press / and enter the IP address of the ComIP you noted in the previous steps.
Pressing / when complete. Pressing the / key twice will enter a dot. For
Example 192.168.0.150
• Scroll down once to change the port number. This is required if you wish to setup port
forwarding through the router. The port can be left as 10001.
• Scroll down and enter the Gateway address assigned to the ComIP.
• Scroll down once and enter the subnet mask assigned to the ComIP
• Press / twice.
• Press then / (Comport Setup).
• Scroll to the comport you have the ComIP plugged onto.
• Press / and / for ComIP module.
The settings will be sent to the ComIP. After a minute the unit will be ready to use.
Exit Engineers mode on the control panel.
The control panel can now be accessed on the LAN. However, to access the panel from the
Texecom mobile apps or Wintex remotely, additional steps are required within the various
programmes and the control panel.
4. Port Forwarding
WARNING: Care should be taken when opening ports as this can leave the router vulnerable to
malicious attacks.
To allow the system to communicate with the outside world, and vice versa, port forwarding must be
enabled on the router for the ComIP. The below example is typical, however please check you
routers documentation or the manufacturers website for more information. This will be required in
order to use the app remotely.
To setup Port Forwarding do the following.
• Connect to the Router
• Look for settings for "Forwarding”, or "Port Forwarding" these could be under advanced
settings, or in the Firewall settings. Each manufacturer is different.
Once you have found the option you will have something like this.
• Add a new rule using the ComIP IP address and Port Number you used earlier.
To Next Page
Loading...
Need help?
General
