TEXI SMART S+B 4
2. IMPORTANT
Before installing Texi Smart S+B, it is necessary to set up the following:
1. Protected electrical outlet suitable to its power (it is recommended to use an earth protector thermo-
magnetic switch 16 A and Id 30 mA).
2. Flat, even surface onto which the machine will be placed.
3. OPENING THE PACKAGE
1. Open the box containing the Texi Smart S+B, take out the instruction manual and read it very
carefully.
2. Remove Texi Smart S+B from the box and insert the cable support deep into the special hole
(fig.1).
3. Fix the cable support spring to the cable support, avoiding twining.
4. Put the iron on the iron rest. (fig. 1).
4. CONNECTING AND STARTING
FUNCTIONS OF KEYS
Vacuum / blowing motor ON/OFF key
Manual / automatic mode switch
Note: in manual mode the vacuum/blowing motor works continuously, in automatic mode the
vacuum/blowing motor works upon pressing the micro-switch of the iron.
Key to change the motor function from vacuum to blowing and
vice-versa.
To Next Page
Loading...
General