Texi Smart S+B User Manual

TEXI SMART S+B 6
When the light is on, the machine works in manual mode (the vacuum / blowing
motor works continuously). When the light is off – the machine works in automatic
mode (the vacuum / blowing motor works upon pressing the micro-switch of the
iron).
Indicates a malfunction which requires technical assistance or that the maximum
number of hours set for the cover changing has been exceeded.
NOTE:
During ironing the icon will start flashing. This is normal and indicates that the heater is working,
restoring the optimum pressure inside the boiler.
If the icon turns on every now and then, this indicates that the Texi Smart S+B is pumping
water into the boiler. It is therefore important to always fill the water tank (fig. 3).
It is possible to change the motor function (vacuum or blowing) and the functioning (continuous or
with iron micro-switch) anytime by using the keys indicated in “FUNCTIONS OF KEYS”.
6. MENU
To access the MENU, press both keys for a few seconds as shown on the left. To
exit the MENU, press ESC or wait for 5 seconds. To scroll up or down use the
arrows.
AVAILABLE SETTINGS:
HOURS OF
WORK
TOTAL HOURS:
Cannot be zeroed
To exit
or wait for 5
seconds
ON/OFF
PARTIAL HOURS:
Zeroing of hours
Press for 6 sec.
TOTAL HOURS: computation of the total hours the machine has worked for. This data cannot be
zeroed.
PARTIAL HOURS: computation of the hours the machine has worked since last zeroing. This data
can be zeroed (see table). To zero the data, follow instructions as per below table.
ON/OFF

Texi Smart S+B Specifications

General

Brand	Texi
Model	Smart S+B
Category	Iron
Language	English