TEXI SMART S+B 5
To access the internal menu press both keys together.
With Texi Smart S+B switched off and disconnected plug:
1. Vertically hold the ironing board, being sure that the boiler is towards the floor;
2. Pull the board legs until the desired height has been reached (fig. 2);
3. Install the electric + steam plug in the socket placed on a side of the steam generator
(Fig. 1.12). Block it with the security cap of the outlet.
4. Take off the water plug of the Texi Smart S+B (fig. 3), and fill the water tank (roughly 1 liter).
Once this has been done, replace the water plug.
5. Insert the plug (Fig. 1.8) into a 230V 16 A socket and turn on the machine by pressing the green
key;
6. Select the desired function (iron, boiler, working mode, etc.).
WARNING: the electronic board automatically performs a check of
the software installed.
If an error or fault is found, the “safety” device blocks the electronic
board and does not allow normal functioning. “SOFTWARE
ERROR” will be displayed. Contact the Authorized Service Centre
to update the software.
Fig. 3
5. MEANING OF ICONS
INTERMITTENT LIGHT: indicates that the boiler is on and water is being heated to
obtain steam
FIXED LIGHT: indicates that the boiler is on and its pressure is optimum Texi Smart
S+B is ready for ironing
Indicates that the iron is functioning
INTERMITTENT LIGHT + SOUND ALARM: indicates that water is missing inside
the water tank.
FIXED LIGHT: indicates that the pump is pumping water into the boiler.
Indicates – when the light is on, the vacuum / blowing motor is on.
Light is off – motor does not work.
To Next Page
Loading...
General