Remove the screws in the clamps (a) and insert Motor Stand in the motor base flange (b) as shown in below
pictures and tight the screws (c).
Fig. 7 Assembly procedure – Motor stand
Similarly assemble the pump stand in the delivery flange as shown in pictures (d), (e) and (f) and tighten the
screws.
Fig. 8 Assembly procedure – Pump stand
Both Motor & Pump Stands should be assembled opposite to the cable side
Motor and pump stand assembly – procedure
Refer Fig. 7 and Fig. 8 for the assembling the motor stand and pump stand.
SVSM – Horizontal Mounting:
(a) (c)(b)
(d) (f)(e)
OMOW002A 17 20 20.01
To Next Page
Loading...
Need help?
General
