5. Information about your pump
The discharge of a pump depends on the static suction
lift. During summer, the static suction lift increases
due to drop in water levels, and this results in reduced
discharge. This will require frequent lowering of
the pump to reduce the static suction lift. During
monsoons, water levels can significantly rise. Under
such conditions, there is a possibility that the pump can
get submerged, resulting in the motor getting damaged.
Such issues are overcome by the use of an openwell
submersible pump as it operates submerged in water.
Single phase monoblock There are three series of Single
Phase Openwell Submersibles:
TSSM
SSM
SVSM
The TSSM and SSM Series are operated horizontally.
However, the SVSM series can be operated vertically
inside a 6-inch borewell as well as horizontally in
a sump / tank by provision of two suitable clamps
supplied along with the product.
Texmo Single Phase Openwell Submersible Monoblocks
are manufactured using high quality raw materials
and components using state-of-the-art manufacturing
facilities and will give trouble-free performance
if properly installed and maintained. These are
compact pumping systems with the pump and motor
mounted on a common shaft. As a coupling is not
required, alignment of the pump and motor is assured.
Installation therefore quick and easy. They do not
require frequent maintenance as the packing rope
and grease-lubricated deep groove ball bearings are
replaced by oilseals and water-lubricated journal
bearings respectively. Such products find application
for irrigation of farms, domestic water supply, cooling
water circulating systems, fountains, dairies, water
supply to high rise buildings, housing complexes,
bungalows, cattle and poultry farms.
Prior to installation, read this manual thoroughly and
follow the instructions for installation and maintenance
of our Single Phase Openwell Submersible Monoblock to
ensure reliable operation. The product should be
installed by technically qualified personnel in
compliance with national and local electrical codes
and as per our instructions in order to avoid electrical
shocks, unsatisfactory performance, and / or
equipment failure.
OMOW002A 5 2020.01
To Next Page
Loading...
Need help?
General
