Texsport 02820 User Manual

Authentic Adventure Gear·




3
2

Assembly Instructions
3

� '
    





INSIDE
I








 





      
      
 
f�I


      


 
 
      
     
 



        
 
 


      

      
       
        
 

Texsport 02820 Specifications

General

Brand	Texsport
Model	02820
Product Type	Tent
Material	Polyester
Floor Material	Polyethylene
Water Resistance	Water-resistant
Frame	Fiberglass
Ventilation	Mesh

Summary

Screen House Assembly Instructions

Step 1: Unpacking and Initial Setup

Unpack screen house and frame, close zippers, spread flat, stretch base to eliminate slack, and drive stakes into corner and side loops.

Step 2: Pole Assembly

Slide sections 4,5,4 through ridge loops. Assemble upright sections 3,2,1 into corner joints. Repeat for other outer ridge sections.

Step 3: Raising the Screen House

Raise one side by bringing pole tips toward stakes, then raise the other side. Adjust for tightness and tie strings at peak pole joints.

Step 4: Final Assembly and Setup

Assemble inner ridge sections 9,10,9 into corner joints, connect to 8,7,6, adjust length, stand pole, and tighten section 7.

Assembly Diagram

Questions and Customer Support