Do you have a question about the Texsport Calypso Cabana and is the answer not in the manual?
Lay out the cabana fabric flat on the ground to begin the setup process.
Assemble one short pole and insert it through the roof sleeve, ferrule end first. Repeat for the second short pole.
Assemble the long pole and thread it through the sleeve on the side of the cabana skin.
Insert the pin and ring into the ferrule end of the long side pole on both ends.
Insert the pin and ring into the ferrule of the back short poles.
Insert the pole pin into the grommeted web strap above the front opening of the cabana.
Tie the poles at the roof top on both sides using the cabana skin ties.
Stake down the cabana at all pole rings to secure it to the ground.
Add weight, such as sand in bags, to further secure the cabana in windy conditions.
Details the components included with the Calypso Cabana: skin, poles, and stakes.
Prepare campsite by removing sharp objects and ensuring a flat, non-depressed surface.
Recommends against open flame use near or in the cabana due to flame retardant treatment.
Advice on staking in windy weather and positioning away from campfires.
Explains potential seam leakage and recommends seam sealing for waterproofing.
Discusses stake types (sand, steel, skewer, snow) and their suitability for different conditions.
Tips for lubricating zippers and avoiding damage from forcing or sand.
Guidelines for storing the cabana dry, away from heat, water, and concrete.
Instructions for hand washing with mild soap and resealing seams after washing.
Factors affecting lifespan, including UV rays, storing wet, and mildew.
Advice on using rip-stop patches for small tears, recommending a specific repair kit.
Contact information for customer service via phone or email for questions or issues.