Textron Bunton BZT 2200D W/52 User Manual

WARNING: If incorrectly used this machine can cause severe injury. Those who use
and maintain this machine should be trained in its proper use, warned of its dangers
and should read the entire manual before attempting to set up, operate, adjust or
service the machine.
2721545 REV02
SETUP, PARTS & MAINTENANCE
MANUAL BZT 2200D SERIES
MODELS: 642225 BZT 2200D W/52" SIDE DISCHARGE
642226 BZT 2200D W/61" SIDE DISCHARGE
Operation & Safety Manual: 2721544

Textron Bunton BZT 2200D W/52 Specifications

General

Brand	Textron
Model	Bunton BZT 2200D W/52
Category	Lawn Mower
Language	English

Summary

California Proposition 65 Warnings

Important Message

Safety Information

Signal Word Definitions

Explanation of DANGER, WARNING, and CAUTION signal words.

Specific Torques

Recommended torque values for key fasteners.

Assembly and Setup Procedures

Tools Required for Assembly

List of tools needed for assembly.

Install Seat

Step-by-step guide for installing the operator's seat.

Traction Levers Adjustment

Adjusting traction levers for proper operation.

Final Preparations

Steps to complete before initial operation.

Maintenance and Servicing

Maintenance Chart

Schedule of maintenance tasks based on operating hours.

Routine Maintenance Checks

Daily maintenance tasks including interlock, hardware, and battery checks.

Lubrication Procedures

Greasing points and frequency for machine components.

Hydraulic System Maintenance

Fluid level checks, oil changes, and filter replacement.

Engine Oil and Fuel Filter Servicing

Procedures for engine oil and fuel filter maintenance.

Air Cleaner Maintenance

Cleaning and replacing the air cleaner element.

Engine Cooling System Care

Cleaning air intake screen, radiator, and cooling fins.

Blade Maintenance and Balance

Instructions for blade removal, sharpening, and balancing.

Troubleshooting Guide

Engine Starting Issues

Troubleshooting engine start and crank problems.

Engine Performance and Shutdowns

Diagnosing engine running issues and unexpected shutdowns.

Adjustments and Settings

Height of Cut Adjustment

Setting the cutting height using the height of cut pin.

Hydrostat Neutral Adjustment

Adjusting the hydrostat for neutral operation.

Belt Replacement Procedures

Engine-Cutterdeck (PTO) Belt

Procedure for replacing the PTO belt.

Cutterdeck and Pump Drive Belts

Replacing cutterdeck and pump drive belts.

Machine Specifications

Power Unit Specifications

Details on engine, controls, fuel, speeds, tires, and seat.

Cutterdeck Specifications

Details on cutterdeck types, dimensions, and production.

Parts Section

Upper Engine Deck Assembly Parts

Parts breakdown for the upper engine deck assembly.

Lower Engine Deck Assembly Parts

Parts breakdown for the lower engine deck assembly.

Hydraulic System Parts

Parts breakdown for the hydraulic system.

52" & 61" Side Discharge Cutter Deck Parts

Parts breakdown for 52" and 61" side discharge cutter decks.