Failure to follow these instructions can result in SERIOUS INJURY or DEATH
Turn the ignition key to the ‘N’ position and ‘chock’ tires to prevent inadvertent movement.
Remove this plastic cover by removing 3 plastic fasteners. See illustrations below.
S
ee emergency brake release instruction under this panel.
609987
Flip the RUN-TOW switch to the ‘TOW’ position and move vehicle to the desired location and
park it properly on level ground and chock tires immediately.
Turn the ignition key to the ‘OFF’ position, remove ke
y and perform required service
procedures following all Safety Guidelines as outlined in your repair manual.
IF VEHICLE IS INOPERABLE AND NEEDS TO BE MOVED:
In Case of Total Power Loss and the ‘Run-tow’ Switch DOES NOT Release
the Brake to Move the Vehicle :
Push center
of fast
ener
with vehicle
key,
depressed
remove.
lift fastener to
When center is
To reuse fastener
push center stem
up then install
fastener
shield into
hole.
through
To secur
e fastener
in place press
down on
center stem
with head of
fastener.
until flush
Brake
1
ELECTRICAL HARNESS ASSEMBLY WITH HD SOLENOID includes items 2 - 13
4
MAIN HARNESS includes items 5 - 10
Motor
Throttle
Switch
Throttle
Sensor
Brake
Switch
Brake
Sensor
Diagnostic
Plug
Motor
Sensor
Temperature
Sensor
12
24
6
13
30
29
23
20
11
27
3
14
22
21
7
28
25
2
5
Front of Vehicle
Front of Vehicle
Front of Vehicle