Textron Greenlee 1818 - 3 Bend Saddles

Greenlee / A Textron Company 10 4455BoeingDr.•Rockford,IL61109-2988USA•815-397-7070
1818 Mechanical Bender
Special Bending Information (cont’d)
Offsets: (Controlling the end of the second bend)
 1. Gotothefollowingchartwhichisforthesizeandtypeofconduityouaretobend.
 2. LookdowntheANGLEcolumnuntilyoucometotheangleyouwanttobendto.
 3. LookatthenumbersintherowprecededbyZandpicktheonethatisdirectlyundertheheight(H)youwant.
 4. SubtractthisZdimensionfromthedesiredlength.
 5. Placeyourrstmarkthisdistancefromtheendoftheconduit.
 6. LookatthenumbersintherowprecededbyL1andpicktheonethatisdirectlyundertheheight(H)youwant.
 7. Placeasecondmarkthisdistancefromyourrstmark.
 8. Makeyourrstbendafterplacingthefrontedgeofthehookontherstmarkandyoursecondbendafter
placingthefrontedgeofthehookonthesecondmark.
3 Bend Saddles:
 1. Gotothefollowingchartwhichisforthesizeandtypeofconduityouaretobend.
 2. LookdowntheANGLEcolumnuntilyoucometotheangleyouwanttobendto.
 3. LookatthenumbersintherowprecededbyZandpicktheonethatisdirectlyundertheheight(H)youwant.
 4. SubtractthisZdimensionfromthedesiredlength.
 5. Placeyourrstmarkthisdistancefromtheendoftheconduit.
 6. LookatthenumbersintherowprecededbyL1andpicktheonethatisdirectlyundertheheight(H)youwant.
 7. Placeasecondmarkthisdistancefromyourrstmark.
 8. LookatthenumbersintherowprecededbyL2andpicktheonethatisdirectlyundertheheight(H)youwant.
 9. Placeathirdmarkthisdistancefromyoursecondmark.
10. Makeyourrstbendafterplacingthefrontedgeofthehookontherstmarkandyoursecondbendafter
placingthefrontedgeofthehookonthesecondmark.Remembertomakethesecondbenddoubletherst
bend.Makeyourthirdbendafterplacingthefrontedgeofthehookonthethirdmark.
←
L1
→
← LENGTH – Z →
←
HEIGHT
→
←
LENGTH TO END OF SECOND BEND
→
ANGLE
BENDING
MARK 1
BENDING
MARK 2
→
→
← L1 →
← LENGTH – Z →
← →
← LENGTH TO CENTER →
ANGLE
BENDING
MARK 1
BENDING
MARK 2
→
→
BENDING
MARK 3
← L2 →
HEIGHT