EK50ML Battery-powered Crimping Tool
Greenlee / A Textron Company
9
Daily
Before use:
1. Inspect the tool for wear or damage, such as cracks,
gouges, or chips.
2. Inspect the tool for damage.
After use:
1. Use a damp cloth and mild detergent to clean the
housing. Allow the housing to dry.
2. Place the tool in the carrying case and store in a
cool, dry place.
3. If necessary, recharge the batteries. Refer to the
instructions supplied with the battery charger.
Monthly
Thoroughly clean all surfaces.
Annually or After 35,000 Crimps
Send the tool to a Greenlee Authorized Service Center
for inspection.
Note: For Warranty Service or Repair, contact Greenlee
customer service at 800-435-0786.
Maintenance
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
ying debris or hydraulic oil.
Do not use solvents or ammable
liquids to clean the tool body.
Solvents or ammable liquids could
ignite and cause serious injury or
property damage.
Pinch points:
• Remove battery before changing
dies, adapters, or jaws.
• Keep hands away from the crimp-
ing tool head when crimping.
Failure to observe these warnings
could result in severe injury or death.
www.calcert.com sales@calcert.com1.800.544.2843
0
5
10
15
20
25
30
To Next Page
Loading...
Need help?
General
