To Next PageTo Next PageWhat to do if my Textron Greenlee TG-2000 Thermometer is showing other errors?
If your Textron Thermometer is showing unexpected errors, try resetting it. Remove the batteries for at least one minute, then reinstall them and check if the operation is normal.
Why Textron Greenlee TG-2000 is not showing correct temperature after a rapid temperature change?
If your Textron Thermometer has been exposed to a rapid temperature change, allow at least 30 minutes for the thermometer to stabilize at the new ambient temperature. This should allow it to provide accurate readings.
Why Textron Greenlee TG-2000 Thermometer doesn't work at certain ambient temperatures?
Your Textron Thermometer may not function correctly if the ambient temperature is outside of its operating limits. Make sure to operate the thermometer within the limits specified in the “Specifications” section.
What to do if the measured temperature is above the range of my Textron Greenlee TG-2000?
If the temperature you are trying to measure is above the specified range of your Textron Thermometer, you should use the thermometer within its specified range. Measuring temperatures beyond the range may cause inaccurate readings or damage the device.
What to do if measured temperature is below range of the Textron Thermometer?
If the temperature you are trying to measure is below the specified range of your Textron Thermometer, ensure that you use the thermometer within its specified range. The thermometer is designed to provide accurate readings within that range.
General| Type | Infrared Thermometer |
|---|---|
| Response Time | <500 ms |
| Display | Backlit LCD |
| Emissivity | Adjustable from 0.1 to 1.0 |
| Battery Type | 9V |
| Battery Life | 12 hours (continuous use without laser and backlight) |
| Operating Temperature | 32 to 122°F (0 to 50°C) |
| Storage Temperature | -20°C to 60°C (-4°F to 140°F) |
| Resolution | 0.1°C/°F |
Details the key features of the TG-2000 Infrared and Contact Thermometer.
Outlines the manual's intent to familiarize personnel with safe operation and maintenance.
Defines the safety alert symbol and signal words (DANGER, WARNING, CAUTION).
Emphasizes reading the manual and basic electrical safety precautions.
Covers hazards related to electricity, laser radiation, and environmental exposure.
Highlights restrictions for medical use, environmental extremes, and EMI interference.
Details compliance with EN standards and CFR regulations for safety.
Labels and identifies the various parts of the TG-2000 thermometer.
Explains the meaning of icons shown on the device display and unit symbols.
Guides on operating basic functions like laser/backlight and advanced modes.
Instructions for setting high and low temperature alarm limits.
Details on using a K-type probe and reviewing recorded measurements.
Explains the 16:1 D:S ratio and its impact on measurement accuracy.
Covers what cannot be measured and how to locate hot spots.
Lists common error codes (Er2, Er3, HI, LO) and their troubleshooting actions.
Illustrates typical measurement applications in electronics, power distribution, and HVAC.
Explains emissivity and methods for determining and compensating it.
Provides a table of common emissivity values and infrared sensor accuracy.
Specifies the accuracy for K-type thermocouple measurements.
Lists key technical specifications including display, range, and operating conditions.
Details the instrument's conformity to ISO 9001 and calibration traceability.
Provides instructions on how to safely replace the device batteries.
Guides on cleaning the lens and housing, emphasizing caution.
