3
Hydro
Midsize
ASSEMBLY/SET-UP INSTRUCTIONS
GENERAL NOTE: FRONT, REAR, RIGHT HAND AND LEFT HAND REFERENCES BELOW
ARE WITH RESPECT TO AN OPERATOR AT THE CONTROLS.
1. UNCRATE - Place shipping crate on a level
surface and remove sides and top.
2. Remove screws securing shipping brackets A to
pallet. Remove two front shipping brackets and
tighten front axle bolts.
3. Remove wire ties B securing tires, upper handle,
parking brake rod, rods, and parts bag.
Support rear of machine at Location C, remove
the shipping brackets and keep the nuts. Install
drive wheels using the nuts removed from the
shipping brackets.
NOTE: One side of the wheel is dished deeper
than the other.
On 36" units install with the deep dish to the
inside.
Tighten wheel nuts securely. Torque to 85ft./lbs.
To Next Page
Loading...
