6
Hydro
Midsize
ASSEMBLY/SET-UP INSTRUCTIONS
14. With the traction locks J in the neutral position,
apply tension to the traction control rod to
remove any slack and align swivel on traction
control rod with the hole in pump arm K and
install washer and hairpin clip. Repeat for other
side.
NOTE: The pump arm has some rotational play.
Adjust the swivel on the traction control rod to the
center of this play and secure to the pump arm
with a atwasher and hairpin as shown.
13. Locate the two longest rods with the single
bend removed in Step 3. Install the two traction
control rods through the traction control lever H,
atwasher and traction lock J and secure with
hairpins. Repeat on other side of upper handle.
NOTE: The at washer in the inside of the traction
control lever.
15. Attach spring to pump arm and then to bolt L.
Repeat for other side.
To Next Page
Loading...
