25
Error Code (blinking) Reason Remedial Measure
• Too much clothes • Please reduce the amount of clothes
and then operate again.
• Motor malfunction • Please contact Towngas Company for
service.
• Lint filter is covered by
thin and less breathable
clothes or mats
• Please remove the less breathable
clothes or the mats and then operate
again.
• The exhaust duct or
exhaust elbow is blocked
• Motor malfunction
• Please contact Towngas Company for
service.
• Gas supply valve of
appliance is closed or
not fully opened
• Please wait for the drum to stop rotation
and then operate again after the gas
supply valve of appliance is fully opened.
• Too much clothes • Please reduce the amount of clothes and
then operate again.
• Motor malfunction • Please contact Towngas Company for
service.
• Insufficient air for
combustion
• Lint filter is blocked by
lint
• Lint filter is covered by
thin and less breathable
clothes
• Too much clothes
• Please wait for the drum to stop rotation
and then operate again after cleaning lint
filter.
• If there are too many clothes , reduce the
amount of clothes or remove the less
breathable clothes and then operate
again.
• Dust has built up inside
the dryer
• The exhaust duct or
exhaust elbow is blocked
• Please contact Towngas Company for
service.
Goes out
• Overheating due to
insufficient air or lint filter
blockage
• Please wait for the drum to stop rotation
and then operate again after inspection.
• Control circuit
malfunction
• Please contact Towngas Company for
service.
Other error code
• Please contact Towngas Company for
service.
T
roubleshooting
To Next Page