EasyManua.ls Logo

TGC RJD650 - Troubleshooting

TGC RJD650
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
24
The digital display shows the related error code in case of malfunction. If the
following remedial measures are not effective, please call Towngas 24-Hour Customer
Service Hotline: 2880-6988.
Error Code (blinking) Reason Remedial Measure
Power is off <Goes out>
Power is off or the power
plug is removed during
operation
When power is restored, SOFTEN
& COOL mode will be operated
automatically. Please wait for the drum
to stop rotation and then operate again.
Power is restored
Insufficient air for
combustion
Filter is blocked by lint
Filter is covered by thin
and less breathable
clothes
Too much clothes
Please wait for the drum to stop rotation.
Then operate again after inspection.
If there is too much clothes , reduce the
amount of clothes or remove the less
breathable clothes, then operate again.
Dust has built up inside
the dryer
The exhaust duct or
exhaust elbow is blocked
Please contact Towngas Company for
service.
Gas supply valve of
appliance is closed or
not fully opened
Please wait for the drum to stop rotation
and fully open the gas supply valve of
appliance. Then operate again.
Gas supply valve of
appliance is not fully
opened
Please wait for the drum to stop rotation
and then operate again after inspection.
Oxygen level is very low
in the room
Please wait for the drum to stop rotation
and then operate again after ensuring
the ventilation is good enough.
The exhaust duct or
exhaust elbow is blocked
Please contact Towngas Company for
service.
Lint filter is blocked by
lint
Too much clothes
Please wait for the drum to stop rotation.
Then operate again after cleaning the
filter.
If there are too much clothes, reduce the
amount of clothes or remove the less
breathable clothes, then operate again.
The START/PAUSE
button is
pressed over 10
seconds
The control panel circuit
malfunctions
Please wait for the drum to stop rotation.
Then operate again after inspection.
If it cannot be operated again, please
contact Towngas Company for service.
T
roubleshooting