6 – ENGLISH
ENGLISH
OWNER’S MANUAL PASS HELMET
Thank you. You have chosen a TSG safety product designed especially for action sport athletes.
Please read the following information carefully. Correctly used and cared for, it will keep you bet-
ter protected and satisfied.
TESTING, APPROVAL & USE
This helmet is intended for downhill skateboarding use only and not for motorized vehicle use
including motorcycles or mopeds! This helmet is designed to protect impact caused by falling or
ejected objects and collision of parts of the body with an obstacle.
The helmets comply with the Personal Protective Equipment Regulation (EU) 2016/425 and pass-
es EN 1078: Helmets for pedal cyclists and for users of skateboards and roller skates.
This helmet has passed EN 1078:2012+A1:2012 to show conformity to the EHSR (Essential
Health and Safety Requirements ) of EU2016/425 as transposed into UK law.
The helmet also complies with ASTM F1952: Standard Specification for Helmets used for Down-
hill Mountain Bicycle Racing.
Find the declaration of conformity for each model on our website:
www.ridetsg.com/service/declaration-of-conformity/
WARNING NOTICES – WARNING!
• For maximum protection the helmet must be fitted and attached properly to the wearer’s
head in accordance with the manufacturer’s fitting instructions.
• This helmet is designed to absorb shock by partial destruction of the energy absorbing
liner. This damage may not be visible to the user. Therefore, if subjected to a severe impact
or blow, the helmet should be destroyed and replaced even if it appears undamaged.
• A helmet can only provide a level of protection for areas that it covers.
It does not protect your neck.
• A helmet can only protect if it fits well and properly to your head and if it is correctly buckled.
• No helmet can protect against all possible impacts.
• Do not modify or remove any of the original component parts of the helmet other than as
recommended by the manufacturer, as it may aect its protective capacity. The helmet must
not be modified to attach accessories in a manner not recommended by the manufacturer.
Do not remove the original stickers on the inside of the helmet.
• Some common substances can cause damage to the helmet, though it may not be visible to
the user. The use of any solvents, transfers, adhesives, paints or cleaning solutions can cause
damage to the helmet and make it ineective in the result of an accident.
• This helmet is for pedal cyclists, skate boarders and roller skaters. ATTENTION! Not for motor
vehicle use.
• Warning! This helmet should not be used by children while climbing or doing other activities
when there is a risk of strangulation/hanging if the child gets trapped with the helmet.
CLEANING
Wipe only with a soft damp cloth in gentle soap or mild detergent in cold water, rinse by wiping
with a soft cloth damped in cold water and dry with a soft cloth. Comfort padding and cheek pads
To Next Page
Loading...
Need help?
General