8 – ENGLISH
ENGLISH
COMFORT LINER AND CHEECKPADS
The comfort liner is connected to the helmet with four snaps. To remove this, gently pull the
comfort liner to release it from the helmet. To reinstall, insert the comfort liner into the helmet,
aligning the front of the liner with the front of the helmet and close the snaps. The cheek pads
are connected to the helmet using 3 snaps. To remove, gently pull the lower corner closest to the
front of the helmet and repeat for each snap until the cheek pad is removed. To reinstall, click
them back into the helmet.
The padding in the cheek area reduces side to side movement. The padding should grip the sides
of your face firmly to do this. If your helmet comes with fittable cheek pads you can adjust the
thickness of the cheek pads to fit your head perfectly (FIG. 3).
FOGGING BLOCKER
The TSG Pass helmet features an Exhalation-Fogging-Blocker installed inside the helmet around
your nose. It blocks exhaled air flowing up to fog the Shield Visor. The Fogging-Blocker is supplied
in two sizes for individual adaptation to dierent facial geometries. To exchange the Fogging-
Blocker carefully separate the Velcro strips at room temperature to remove the Blocker on the
inside of the helmet and install the other size.
HOW TO REMOVE THE VISOR
With the visor in a closed position, use a flat head screwdriver to turn both screws anti-clockwise.
The visor and the covers will slip out of their holder.
HOW TO INSTALL VISOR
Choose preferred visor and place in closed position. Mount onto the position-rondels and insert
the black covers. Slowly tighten both screws by turning clockwise until secure. To open and close
the visor only use the central handle.
SUBSTANCES
TSG helmets are made of high-tech materials for optimal functionality. The Pass Pro helmet is
made of a multi-layered fiberglass shell, a core of impact absorbing EPS and a soft polyester
comfort liner. TSG visor lenses are made of polycarbonate.
WARRANTY
This product has been manufactured to the highest quality standards, tested and approved ac-
cording to the relevant standards. The original buyer is entitled to a warranty period of 24 months
from the date of purchase on the material and workmanship with presentation of proof of pur-
chase. The warranty does not cover damage caused by accident, misuse, alterations to the prod-
uct, normal wear and tear and improper handling of the product. The original stickers on the
inside of the helmet must not be removed. To view the current complete warranty please visit
https://www.ridetsg.com/service/terms-conditions. TSG waives all responsibility for any third
party for consequences that might result from the use or handling of any TSG product by any
legal or natural person.
To Next Page
Loading...
Need help?
General