The Pond Guy ClearSolution G2 - Page 10

MAINTAINING YOUR CLEARSOLUTION
™
FILTER:
Step 15
Remove Impeller
Remove the pump cap to expose the impeller, then
pull gently to remove impeller.
Step 16
Reassemble
Wash all parts with clean water and check for any wear
or debris trapped inside the pump. Reassemble the
impeller and pump cap.
Step 17
Reassemble Filter
Place the pump and UV back into the lter housing.
Install lter media pads. Note: Media pads may be
rinsed throughout the season anytime water ow
is reduced. Avoid using chlorinated tap water or
detergents, which will strip the media of
benecial bacteria.
Step 18
Reinstall Filter
Reconnect the diverter and fountain assembly and any
additional water features. Place the lter unit back into
the pond. Plug in the pump and UV, and then adjust
the fountain spray and diverter ow.
Winter Storage
The ClearSolution™ G2 Filter should not be operated during freezing temperatures and
should be disconnected, drained, cleaned and stored for the winter.
Model 700
Model 1250
thepondguy.com | 866-POND-HELP (766-3435)
10