Need help?Do you have a question about the The t.racks DSP 206 and is the answer not in the manual?
Details the buttons, indicators, and display on the device's front panel.
Describes the power input, network, serial, and audio output/input connectors on the rear.
Steps to power on the digital speaker management system and its initial status.
Steps for installing the control software and connecting the device via USB.
Details the buttons, indicators, and display on the device's front panel.
Describes the power input, network, serial, and audio output/input connectors on the rear.
Steps to power on the digital speaker management system and its initial status.
Steps for installing the control software and connecting the device via USB.
General| Input Channels | 2 |
|---|---|
| Output Channels | 6 |
| Frequency Response | 20 Hz - 20 kHz |
| Dynamic Range | >110 dB |
| Signal-to-Noise Ratio | >110 dB |
| EQ | Yes |
| Crossover | Yes |
| Limiter | Yes |
| Polarity | Yes |
| Presets | Yes |
| Display | LCD |
| Inputs | XLR, TRS |
| Outputs | XLR |
| Input Impedance | 10 kΩ |
| Output Impedance | 100 Ω |
| THD+N | <0.01% |
| Total Harmonic Distortion | <0.01% @ 1kHz |
To Next Page
