EasyManuals Logo

Thecus N2310 User Manual

Thecus N2310
14 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
Install Intelligent NAS
If there is any data on your drives, a “Data found on disk” window will pop up and warn you. If
you want to continue, select the “Continue” option. Otherwise select “Shutdown” to cease system
installation.
During the process, it will display drives’ status: "Initializing" and then "Installing RPM ". You might
need to wait for a few minutes (the time it takes depends on the hard drive capacity, and whether
there is data on the drives). When system installation is complete, it will beep and you can click to
begin using the device.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thecus N2310 and is the answer not in the manual?

Thecus N2310 Specifications

General IconGeneral
Memory512MB DDR3
Drive Bays2
RAID SupportRAID 0, 1, JBOD
Power SupplyExternal Power Adapter, 60W
Network InterfaceGigabit Ethernet
Supported Drives3.5" SATA HDD
Operating SystemThecusOS
Power Consumption18W (Operation)
ProtocolsSMB/CIFS, NFS, FTP, AFP, WebDAV
Maximum Capacity12TB (2 x 6TB HDD)

Related product manuals