ThePondguy AllClear G2 2000 - Important Safety Information; DANGER: Essential Safety Precautions; WARNING: Electrical Hazard Mitigation; CAUTION: Equipment Protection Guidelines

IMPORTANT INFORMATION:
Please read these instructions thoroughly before use. Failure to follow instructions may
result in equipment damage or failure, losses, injury or death.
DANGER:
To avoid possible electric shock:
• If the power cord has been damaged, DO NOT operate, the AllClear™ G2 Filter unit should be replaced.
• Prior to installation, inspect the quartz sleeve and UVC bulb to ensure there was no damage during
transportation.
• After installation, the AllClear™ G2 Filter should be examined to ensure there is no water on parts not
intended to be wet.
• If the AllClear™ G2 Filter shows signs of any water leakage, immediately unplug it from the power source.
• If the AllClear™ G2 Filter falls into the water, DO NOT reach for it. First unplug and then retrieve it.
• Close supervision is necessary when the unit is used by or near children.
WARNING:
To reduce the risk of electric shock:
• Connect only to a properly grounded receptacle, which is serviced by a Ground Fault Circuit
Interrupter and never remove the ground pin from the plug.
• Provide a “drip loop” for the power cord. This is a loop in the cord below the level of the receptacle or
plug that prevents water from traveling along the cord in the direction of the receptacle.
• ALWAYS unplug the AllClear™ G2 Filter from power source when it is not in use, and before installing,
removing or servicing the AllClear™ G2 Filter components.
• If an extension cord is necessary, a cord with a proper rating should be used. A cord may overheat if
the cord is rated for less amperes or watts than the unit rating.
• DO NOT immerse the AllClear™ G2 Filter or plug in water or attempt to use a wet plug. Minimum
safety distance between unit and water is 6.5ft.
• The AllClear™ G2 Filter is NOT suitable for use in swimming pools, swimming ponds, or other
situations where bodily contact is made with the water. Although the AllClear™ G2 Filter is designed
for outdoor use, it should never be submerged in water.
Avoid contact with the UVC light. Light omitted can be harmful to the eyes and skin.
CAUTION:
To reduce the risk of equipment damage or failure:
• DO NOT place the AllClear™ G2 Filter in direct sunshine.
• DO NOT place the AllClear™ G2 Filter near ammable or other dangerous materials or objects.
• DO NOT use the AllClear™ G2 Filter for uids other than water.
• ALWAYS unplug the unit if there is no water running through it to prevent over heating.
• The AllClear™ G2 Filter is NOT submersible; do not place the AllClear™ G2 Filter where it might contact
or fall into the water. Partial burial of the unit is recommended
• DO NOT operate during freezing conditions. Disconnect, drain and store the AllClear™ G2 Filter in a
protected location.
• DO NOT operate the AllClear™ G2 Filter with a pump larger than the maximum ow rate indicated
by the lter specications. Operating with a pump larger than recommended can reduce the lters
eectiveness and cause damage to the lter or UVC and will NOT be covered under warranty.
• ALWAYS cap the backush outlet when not in use to avoid unintended draining.
IMPORTANT:
The Pond Guy® is not responsible for equipment damage or failure, losses, injury or death
resulting from failure to follow safety precautions, misuse or abuse of equipment.
thepondguy.com | 866-POND-HELP (766-3435)
2