EasyManua.ls Logo

Thermador RDDS30V - User Manual

Thermador RDDS30V
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
INSTALLATION INSTRUCTIONS MANUAL
30" BUILT-IN RANGES WITH COOK'N'VENT
ELECTRIC MODEL RED30V
DUAL-FUEL MODEL RDDS30V
PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
IMPORTANT: Save these instructions for the local electrical inspector’s use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
OWNER: Please retain these instructions for future reference.
IMPORTANT:
LOCAL
CODES
VARY.
INSTALLATION,
ELECTRICAL
CONNECTIONS
AND
GROUNDING
MUST
COMPLY
WITH
ALL
APPLICABLE
CODES.
Check your local building codes for the proper method of
installation. In the U.S.A., if there are no applicable local codes,
this unit should be installed in accordance with the National Fuel
Gas Code #Z223.1-Current Issue, and the National Electrical
Code ANSI/NFPA No. 70 Current Issue. (In Canada, installation
must be in accordance with the CAN 1-B149.1 and .2 - Installation
Codes for Gas Burning Appliances and/ or local codes).
MOBILE home installation must conform with the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280
{formerly the Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD (Part 280)} or, when such standard is
not applicable, the Standard for Manufactured Home Installations,
ANSI A255.1 / NFPA501A, or with local codes.
Ne pas emmagasiner ou utiliser de l’essence
ou des autres vapeurs inflammables et liquides
aux endroits de celui-ci ou aucun autre
appareil.
CE QUI FAIRE SI VOUS SENTEZ LE GAZ
Ne pas essayer d’allumer aucun appareil
Ne pas toucher aucun interrupteur
électrique; ne pas utiliser aucun téléphone
dans votre bâtiment.
Appeler immédiatement votre fournisseur
de gaz du téléphone d’un voisin. Suivre
l’instruction du fournisseur de gaz.
Si vous ne pouvez pas contacter votre
fournisseur, téléphoner le service des
incendies.
L’installation et le service doivent être
exécutés par un installateur qualifié, une agence
de service ou le fournisseur de gaz.
WARNING: If the information in this manual
is not followed exactly, a fire or explosion may
result causing property damage, personal
injury or death.
UL LISTED #157J FILE # E521958
AVERTISSEMENT: Avant l’installation, COUPER au tableau de service, et fermer a clef le tableau de service
pour empecher l’alimination d’etre allumée per hasard.
WARNING: Before installing turn power OFF at the service panel. Lock service panel to prevent
power from being turned ON accidentally.
AVERTISSEMENT: Si l'information dans ce
manuel n'est pas suivie exactement, un feu ou
une explosion peut résulter et causer des dégâts
matèriels et des risques d'accidents, ou la mort.
Do not store or use gasoline or other
flammable vapors and liquids in the vicinity
of this or any other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try to light any appliance.
Do not touch any electrical switch; do not
use any phone in your building.
Immediately call your gas supplier from a
neighbor's phone. Follow the gas supplier's
instructions.
If you cannot reach your gas supplier, call
the fire department.
Installation and service must be performed
by a qualified installer, service agency or the
gas supplier.

Other manuals for Thermador RDDS30V

Question and Answer IconNeed help?

Do you have a question about the Thermador RDDS30V and is the answer not in the manual?

Summary

Installation Instructions

Safety and Code Compliance

Ensuring installation, electrical, and grounding adhere to local codes and standards.

Safety Warnings

General Safety Precautions

Key safety guidelines to reduce risks of fire, electric shock, and personal injury.

Ventilation and Cabinet Considerations

CooknVent System Overview

Details on the retractable rear ventilation intake and integral plenum.

Cabinet Preparation and Clearances

Instructions for countertop cutout and cabinet clearances for proper installation.

Gas and Electrical Connections

Gas Connection Details

Gas pressure, supply location, and routing for natural and propane gas.

Electrical Connection Requirements

Voltage, phase, circuit, and grounding for electrical hookup.

Blower Electrical Connection

Wiring instructions for integral and remote blower systems.

Installing the Ventilation System

Remote Blower Installation

Steps for mounting and connecting a remote blower unit.

Integral Blower Installation

Guidance for installing the blower directly integrated with the range.

Integral Blower Ducting

Instructions for right, left, rear, and floor ducting for integral blowers.

Remote Blower Ducting and Adapters

Overview of remote blower systems and connecting ducting adapters.

Remote Blower Duct Sizing

Guidance on selecting and sizing ducts and fittings for remote blowers.

Blower Duct Sizing

Calculating Airflow and Equivalent Length

Method to calculate air flow requirements and equivalent duct length.

Duct Fitting Equivalent Lengths

Table of equivalent lengths for various duct fittings and adapters.

Anti-Tip Bracket Installation

Wall Mounted Anti-Tip Bracket

Procedure for securing the anti-tip bracket to a wall stud.

Floor Mounted Anti-Tip Bracket

Alternative method for installing the anti-tip bracket on the floor.

Summary

Installation Instructions

Safety and Code Compliance

Ensuring installation, electrical, and grounding adhere to local codes and standards.

Safety Warnings

General Safety Precautions

Key safety guidelines to reduce risks of fire, electric shock, and personal injury.

Ventilation and Cabinet Considerations

CooknVent System Overview

Details on the retractable rear ventilation intake and integral plenum.

Cabinet Preparation and Clearances

Instructions for countertop cutout and cabinet clearances for proper installation.

Gas and Electrical Connections

Gas Connection Details

Gas pressure, supply location, and routing for natural and propane gas.

Electrical Connection Requirements

Voltage, phase, circuit, and grounding for electrical hookup.

Blower Electrical Connection

Wiring instructions for integral and remote blower systems.

Installing the Ventilation System

Remote Blower Installation

Steps for mounting and connecting a remote blower unit.

Integral Blower Installation

Guidance for installing the blower directly integrated with the range.

Integral Blower Ducting

Instructions for right, left, rear, and floor ducting for integral blowers.

Remote Blower Ducting and Adapters

Overview of remote blower systems and connecting ducting adapters.

Remote Blower Duct Sizing

Guidance on selecting and sizing ducts and fittings for remote blowers.

Blower Duct Sizing

Calculating Airflow and Equivalent Length

Method to calculate air flow requirements and equivalent duct length.

Duct Fitting Equivalent Lengths

Table of equivalent lengths for various duct fittings and adapters.

Anti-Tip Bracket Installation

Wall Mounted Anti-Tip Bracket

Procedure for securing the anti-tip bracket to a wall stud.

Floor Mounted Anti-Tip Bracket

Alternative method for installing the anti-tip bracket on the floor.

Thermador RDDS30V Specifications

General IconGeneral
BrandThermador
ModelRDDS30V
CategoryRanges
TypeDual Fuel Range
Width30 inches
Cooktop SurfaceStainless Steel
Number of Burners4
Oven Capacity4.4 cu. ft.
Self-CleaningYes
ConvectionYes
Color OptionsStainless Steel
Fuel TypeDual Fuel

Related product manuals