Thermann Owner’s Guide
Gas Continuous Flow Water Heaters
14
Inlet water filter
If the inlet water filter is covered with debris, the
hot water may not run smoothly, or the Water
Heater may put out cold water. Check and clean the
filter as explained below.
To prevent burns or scalding, turn off the
Operation button and wait until the appliance
cools before draining the water.
WARNING
1. Close the water supply valve.
NOTE
Do not lose the Sealing.
2. Open all hot water fixtures.
3. With a bucket ready, remove the inlet water
filter. (about 1 L will drain out)
4. Clean the inlet water filter with a brush under
running water.
5. Reattach and close inlet water filter.
6. Close all hot water fixtures.
7. Open the water supply valve and check that
water does not leak from the inlet water filter.
(e.g. TH26ENG5N)
Sealing
Inlet water filter
Water Supply Valve
To Next Page
Loading...
