Thermann Owner’s Guide
Gas Continuous Flow Water Heaters
2
Thank you for purchasing this THERMANN Gas Water Heater.
Before using, please:
Read this manual completely for operating instructions.
Confirm warranty and proof of purchase.
Keep this manual where it can be found whenever necessary.
Installation must conform with Plumbing Code of Australia (PCA) and local codes or in the absence of local
codes, AS/NZS 5601, AS/NZS 3500.4, AS/NZS 3000 wiring regulations and all Local Building, Water and Gas fitting
regulations.
Reece reserves the right to discontinue, or change at any time, the designs and/or specifications of its products
without notice.
* Note: This appliance requires a minimum flow rate to operate of 1.5-2.5 litres/min., water fixtures with a flow
rate of 7.5 litres/min. or higher are recommended.
For optimum performance we recommend installation of THERMANN optional temperature controllers.
FOR CONTINUED SAFETY OF THIS APPLIANCE IT MUST BE INSTALLED, OPERATED AND MAINTAINED IN
ACCORDANCE WITH THE MANUFACTURER’S INSTRUCTIONS.
WARNING
To Next Page
Loading...
