Thermann Owner’s Guide
Gas Continuous Flow Water Heaters
6
Do not use a broken or modified power cord.
Do not bind, bend or stretch power cords.
Do not scratch, modify, or subject them
to impact or force. If the supply cord is
damaged, it must be replaced by the
manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Do not cover the Water Heater, store trash or
debris near it, or in any way block the flow of
fresh air to the appliance.
Do not touch the exhaust vent during or
immediately after operation of the Water
Heater.
Be sure to electrically earth the appliance.
Keep power cord free of dust.
Do not use the Water Heater for other than
hot water supply, shower and bath.
Do not exchange a remote controller cord
without notice.
Do not turn off the Water Heater while
someone is bathing.
CAUTION
If the appliance delivers water in excess of
50°C, the following warning must be adhered
to:
THIS APPLIANCE MAY DELIVER WATER
AT HIGH TEMPERATURE. REFER TO THE
PLUMBING CODE OF AUSTRALIA (PCA),
LOCAL REQUIREMENTS AND INSTALLATION
INSTRUCTIONS TO DETERMINE IF
ADDITIONAL DELIVERY TEMPERATURE
CONTROL IS REQUIRED.
If the appliance is 50°C locked model, the
following statement & warning must be
adhered to:
THIS APPLIANCE DELIVERS WATER NOT
EXCEEDING 50°C IN ACCODRANCE WITH AS
3498.
WARNING — THIS APPLIANCE MUST ONLY
BE INSTALLED IN ACCORDANCE WITH THE
ACCEPTABLE PLUMBING CONFIGURATIONS
SPECIFIED IN THESE INSTRUCTIONS. FAILURE
TO DO SO MAY RESULT IN CONDITIONS
WHERE DELIVERY TEMPERATURE CONTROL
IS INADEQUATE.
WARNING
To Next Page
Loading...
