Need help?Do you have a question about the Thermia Calibra Cool and is the answer not in the manual?
Provides an overview of the manual's purpose and scope for installers.
Highlights critical safety warnings and symbols to prevent injury or damage.
Details safety precautions for electrical installations, including isolation methods.
Specifies requirements for safety valve pipes and their connection to the drain.
Outlines procedures and regulations for safely scrapping the heat pump.
Step-by-step guide on how to empty the water tank before unit disposal.
Discusses the importance of water quality and measures to maintain system performance.
Describes the intended uses and variations of the Calibra Cool models.
Provides guidance on determining the optimal collector length for BW models.
Illustrates the overall system with key components and flow paths.
Presents detailed physical dimensions and technical specifications of the Calibra Cool unit.
Lists all components included in the product delivery package.
Covers safe transportation methods, tilt limits, and handling precautions for the unit.
Advises on optimal placement, clearance, and environmental considerations for installation.
Details the hydraulic connections for the heating and hot water systems.
Shows different options for connecting brine pipes to the heat pump.
Provides essential information and tips for making secure brine pipe connections.
Step-by-step guide for connecting brine pipes via the left-side knock-out holes.
Step-by-step guide for connecting brine pipes via the right-side knock-out holes.
Step-by-step guide for connecting brine pipes via the top knock-out holes.
Outlines the general requirements for connecting sensors and the main power supply.
Guides on the correct placement and wiring of the outdoor temperature sensor.
Details the correct connection of the 400V three-phase power supply to the unit.
Explains how to connect an optional external reversing valve for cooling circuits.
Specifies the recommended fuse sizes and circuit breaker types for 400V operation.
Provides the procedure for filling and removing air from the brine circuit.
Instructions on how to access advanced settings using the installer code.
Guides on how to change the language displayed on the unit's interface.
Steps to set the correct date and time for the heat pump's operation.
Configuration options for the internal immersion heater's operation.
How to configure the system for floor heating or radiator systems.
Method for adjusting the heat curve to match heating requirements.
Overview of settings like seasonal stop, min/max supply temperature, and comfort factor.
How to easily adjust the desired indoor temperature via the comfort wheel.
Further explanation of heating settings and their impact on climate.
Explains the meaning of various symbols displayed on the unit's interface.
Steps to activate and run manual tests for system components.
Guide to selecting the desired operating mode (Heating, Cooling, Auto, Off).
Instructions for connecting the heat pump to the internet for remote monitoring.
How to enable and configure the brine monitoring function for freeze protection.
Information on common alarms, their causes, and how to resolve them.
How to activate and adjust cooling settings for standard models.
Configuration for cooling operation when no indoor sensor is installed.
Configuration for cooling operation when an indoor sensor is installed.
Setting the outdoor temperature threshold to start the cooling season.
Options for selecting hot water production modes (Economy, Normal, Comfort).
Explains the meaning of display symbols and controls not covered elsewhere.
Introduces the availability of extra features and accessories for the heat pump.
Guides on how to activate and configure additional accessories and functions.
Detailed diagrams and explanations of the 400V electrical connections for installation.
To Next Page
General
