5. Open your selection by pressing the right button once. A graph of
the hot water temperature over the last hour is shown.
6. Press the left button three times to exit the menu.
To view the TEMPERATURE history:
1. Press either the right or left button once to open the INFORMA‐
TION menu. The cursor is in the OPERATION menu option.
2. Press the down button to move the cursor to the TEMPERATURE
menu option.
3. Open the menu by pressing the right button once.
4. The cursor is at the OUTDOOR value.
5. Press the up or down button to move the cursor to the desired
value.
6. Open your selection by pressing the right button once. A graph
appears in the display.
7. Move the cursor along the time axis using the up (plus) or down
(minus) buttons. An exact value at the relevant time is shown at
the top of the display.
8. Press the left button three times to exit the menu.
5.8 Calculating energy consumption
Diplomat models
The energy consumption calculation is difficult to specify exactly, but the
average output for a normal house with normal hot water consumption
in the following tables gives a relatively accurate result for each heat
pump and heating system. Remember that the operating time for the
heat pump installation must exceed one year before the specified values
in the table are valid.
The energy consumption for legion operation is included in the hours for
ADD.HEAT 1.
28 – User manual 086U6297 Rev. 6 EN
To Next Page
Loading...
Need help?
General