Need help?Do you have a question about the Thermia Legend and is the answer not in the manual?
How to use control buttons to navigate the menu for common settings.
General safety warnings, appliance use by children/impaired, and maintenance by qualified installers.
Only qualified installers can perform installation, operation, maintenance, and repair work.
Details the heat pump system, components (compressor, heat exchanger), and control equipment.
Guides on selecting operating modes: OFF, AUTO, COMPRESSOR, AUX. HEATER, HOT WATER.
Adjusting indoor temp via heat curve and room settings for efficiency & comfort.
Steps to adjust the ROOM value for quick indoor temperature adjustments.
Fine-tuning heat curve parameters for optimal heating based on outdoor conditions.
Discusses factory settings for hot water comfort, availability, and special occasions.
Accessing and interpreting operating data like temperatures, pressures, and operating times.
Lists common accessories and notes that installed accessories affect display settings.
Explains how alarms are displayed and their impact on operation.
Details common alarms (motor, overheat, pressure) and initial troubleshooting steps.
Recommends system checks for maintenance, efficiency, and lifespan, advising controller adjustments.
Checking and maintaining correct water pressure in the heating system, typically around 1 bar.
Checking the brine level in the vessel and contacting an installer if unsure about filling.
Frequency and method for checking safety valves to prevent lime deposits and ensure function.
Immediate actions for leakage in hot water pipes or brine circuit, including shutting off supply.
How to clean heating and brine circuit filters, noting potential issues and instructions.
Explains symbols and messages displayed on the heat pump for status and operation.
To Next Page
General
