- 7 -
FluidsFluids
FluidsFluids
Fluids
The selected fluid must have a viscosity of 50 centistokes or less at the
lowest operating temperature.
Never use flammable or corrosive fluids with this unit.Never use flammable or corrosive fluids with this unit.
Never use flammable or corrosive fluids with this unit.Never use flammable or corrosive fluids with this unit.
Never use flammable or corrosive fluids with this unit.
Cooling ProbesCooling Probes
Cooling ProbesCooling Probes
Cooling Probes
Three cooling probes (or evaporator heads) are available with CryoCool
units: F (flexible), FV (flexible, very), and R (rigid). Refer to Section II,
Specifications to determine the specific cooling probe on your unit.
Place the cooling probe in the work area. For maximum cooling efficiency,
the probe should be fully immersed in the fluid and should be located as
close as possible to the agitator or stirrer motor (if so equipped).
Care should be taken not to stretch or bend the probe beyond it limitsCare should be taken not to stretch or bend the probe beyond it limits
Care should be taken not to stretch or bend the probe beyond it limitsCare should be taken not to stretch or bend the probe beyond it limits
Care should be taken not to stretch or bend the probe beyond it limits
or exceed its minimum bend radius. Bend the probe only at roomor exceed its minimum bend radius. Bend the probe only at room
or exceed its minimum bend radius. Bend the probe only at roomor exceed its minimum bend radius. Bend the probe only at room
or exceed its minimum bend radius. Bend the probe only at room
temperatures, never bend it when it is cold.temperatures, never bend it when it is cold.
temperatures, never bend it when it is cold.temperatures, never bend it when it is cold.
temperatures, never bend it when it is cold.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...