7156161
Motor Replacement Kit
3950/3951, 3960/3961, 3850 Reach-In Incubators
Important service instructions follow. Read and understand the
information before starting this procedure.
Warning Potential electrical hazards. Only qualified persons should
perform the following procedures.
▲
Warning Equipment being serviced must be turned off and disconnected
from the power source to prevent possible injury.
▲
Tools required: Common hand tools
Retain all disassembled parts for re-installation, unless specified otherwise..
1. Move any product inside this unit to another location.
2. Press the unit power switch to the OFF position.
3. Disconnect the power cord at both ends.
4. Allow the unit to cool before servicing.
5. Remove the shelves and shelf channels.
6. Using a #2 Phillips screwdriver, remove the
screws that secure the top duct (Figure 1).
Application
Model
Instruction Sheet
Figure 1. Remove Screws
Disassembly
To Next Page
Need help?
General
