Need help?Do you have a question about the Thermo Scientific 3598 and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | 3598 |
| Category | Accessories |
| Language | English |
Describes the incubator's four basic modes: Run, Setpoints, Calibration, and Configuration.
Provides instructions for proper placement, clearance, and lifting of the incubator unit.
Covers connecting the incubator to a grounded, dedicated electrical circuit.
Details connecting the CO2 gas supply, regulator requirements, and purity.
Outlines steps to enter system setpoints after installation and connection.
Guides on how to set the desired operating temperature setpoint.
Explains how to set the overtemperature safety setpoint for protection.
Details how to set the desired CO2 concentration setpoint for the incubator.
Explains calibration for T/C CO2 sensors, considering atmospheric factors.
Details calibration for IR CO2 sensors, noting temperature change effects.
Defines the deviation from setpoint that triggers a low temperature alarm.
Sets the deviation from setpoint for a low CO2 alarm.
Sets the deviation from setpoint for a high CO2 alarm.
Describes the alarm for a failure in the temperature control system.
Covers alarms indicating issues with any of the incubator's sensors.
Provides information and procedures for performing the high-temperature sterilization cycle.
Specifies temperature control, setpoint, range, uniformity, and display.
To Next Page