Need help?Do you have a question about the Thermo Scientific 3111 and is the answer not in the manual?
General| Category | Accessories |
|---|---|
| Manufacturer | Thermo Scientific |
| Compatibility | Atomic Absorption Spectrometers |
| Material | Graphite |
| Application | Atomic Absorption Spectroscopy |
Provides instructions on how to properly position and install the incubator unit.
Steps for safely connecting the incubator to a grounded electrical power source.
Procedure for filling the incubator's water jacket with the correct type of water.
Instructions for filling the humidity pan to maintain optimal chamber humidity.
Details on connecting CO2 or N2 gas supplies to the incubator's system.
Steps to follow after installation for the initial power-up and setup of the incubator.
Procedure for setting the desired operating temperature for the incubator chamber.
How to configure the independent overtemperature safety circuit setpoints.
Guide to setting the desired CO2 concentration within the incubator chamber.
Instructions for setting the O2 concentration for models equipped with O2 control.
Steps to calibrate the incubator's temperature sensor against a reference instrument.
Procedure for calibrating the Thermal Conductivity CO2 sensor.
Instructions for calibrating the Infra-Red CO2 sensor.
Steps for calibrating the oxygen sensor, including the 20.7% method.
Detailed steps for cleaning the inside of the incubator chamber and its components.
Steps for safely removing and installing a new O2 sensor fuel cell.
List of common spare parts available for all incubator models.
Diagrams illustrating the main power connections and control circuitry of the incubator.
Schematics detailing sensor connections, optional boards, and wiring references.
Details of the USA warranty coverage, period, exclusions, and claims process.
To Next Page
