Need help?Do you have a question about the Thermo Scientific 3130 and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | 3130 |
| Category | Accessories |
| Language | English |
Defines the proper applications and target users for the CO2 incubator.
Important information before requesting warranty service.
Details on specific repairs that are not included in the warranty agreement.
Explanation of the incubator's control panel keys, displays, and indicators.
Details on navigating and operating the incubator using the control panel modes.
Instructions for properly placing and positioning the incubator.
Guidelines for safely connecting the incubator to a grounded power source.
Procedure for filling the incubator's water jacket with the correct water type.
Instructions for filling the humidity pan to maintain chamber humidity.
Guidance on connecting CO2 or N2 gas cylinders to the incubator.
Steps to follow after installation for initial incubator operation.
How to set the desired operating temperature for the incubator chamber.
Configuring the independent over-temperature safety circuit.
Procedure for setting the desired Carbon Dioxide (CO2) level in the chamber.
Procedure for setting the desired Oxygen (O2) level in the chamber (if equipped).
Process for calibrating the incubator's temperature sensor.
Steps for calibrating the Thermal Conductivity CO2 sensor.
Procedure for calibrating the Infra-Red CO2 sensor.
Steps for calibrating the Oxygen (O2) sensor system.
Performing O2 calibration using the ambient air reference point.
Procedure for calibrating the relative humidity sensor.
Step-by-step guide for cleaning the inside of the incubator chamber.
Guide for replacing the incubator's O2 sensor fuel cell.
Replacement parts applicable to all incubator models.
To Next Page