Need help?Do you have a question about the Thermo Scientific 311 and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | 311 |
| Category | Accessories |
| Language | English |
Explains control panel interface elements and their functions, including keys, indicators, and display types.
Details the four basic modes (Run, Setpoints, Calibration, Configuration) and key functions for operating the incubator.
Provides instructions for properly positioning and installing the incubator unit, including clearance and surface requirements.
Guides the user on how to correctly install the internal shelves within the incubator chamber.
Explains how to ensure the incubator is level using the adjustable feet for stability and proper operation.
Guides the user on connecting the incubator to a suitable grounded, dedicated electrical power source.
Instructions on filling the humidity pan with the correct type and level of sterile water for optimal humidity.
Details the proper procedure for connecting the CO2 gas supply, including regulator and purity requirements.
Steps for initiating incubator operation after installation and connection, including entering system setpoints.
How to set the desired operating temperature for the incubator via the control panel.
Explains how to configure the independent overtemperature safety setpoint for protection.
Guides on setting the desired CO2 concentration level for the incubator's control system.
Procedure for calibrating the incubator's temperature control system using a calibrated instrument.
Steps for calibrating the thermal conductivity CO2 sensor, including stabilization periods.
Instructions for calibrating the infrared CO2 sensor, noting automatic calibration cycles.
Procedure for calibrating the relative humidity sensor/display, including stabilization and adjustment.
Detailed procedures for cleaning and disinfecting the internal surfaces of the incubator chamber.
Instructions for accessing and replacing the incubator's internal power fuses.
Proper method for connecting CO2 gas tanks to the incubator's Gas Guard system.
How the Gas Guard system operates, including automatic switching and alarms.
Environmental and safety operating parameters like altitude, temperature, and humidity limits.
To Next Page