Need help?Do you have a question about the Thermo Scientific 8000DH Series and is the answer not in the manual?
General| Type | Ductless Fume Hood |
|---|---|
| Series | 8000DH |
| Airflow | Varies by model; consult product literature |
| Noise Level | Varies by model; consult product literature |
| Dimensions (WxDxH) | Varies by model; consult product literature |
| Weight | Varies by model; consult product literature |
| Filter Type | Activated Carbon, HEPA |
Provides contact details and support channels for Thermo Scientific products.
Key information to have ready before contacting technical services for warranty.
Lists specific conditions and services that are not covered by the manufacturer's warranty.
Details on navigating the incubator's control panel and modes.
Step-by-step instructions for physically placing the incubator.
Guidance on safely stacking multiple incubator units.
Steps for cleaning the incubator interior before initial use.
Instructions for installing internal duct sheets and shelf channels.
Procedures for installing access port filters and CO2 sensor cover.
Steps for correctly installing the air sample filter assembly.
Instructions for installing the HEPA filter into the incubator.
Method for ensuring the incubator is level for optimal performance.
Procedures for safely connecting the incubator to an electrical power source.
Guidance on filling the humidity pan with appropriate water.
Instructions for connecting the CO2 gas source to the incubator.
Steps for initial power-on and basic setup of the incubator.
Procedure for calibrating the incubator's temperature sensor.
Steps for calibrating the Thermal Conductivity and Infrared CO2 sensors.
Specific calibration steps for the Infrared CO2 sensor.
Procedure for calibrating the relative humidity sensor.
Setting up audible alarms, HEPA filter reminders, and access codes.
Configuring low/high limits for temperature and CO2 alarms.
Setting new zero and span numbers for T/C CO2 sensors.
Setting low RH alarm limits and enabling RH alarms to trip contacts.
Options for configuring the display of temperature and humidity.
Description of incubator alarms, messages, delays, and relays.
Details on Temp Controller Failure (TMP CNTR ERR) and Sensor Fault Alarms.
Importance of regular maintenance and general tips for incubators.
Instructions for cleaning the inside of the incubator chamber.
Procedures for cleaning the incubator exterior and humidity pan.
Steps for HEPA filter replacement and power fuse replacement.
Detailed steps and precautions for performing the sterilization cycle.
How to connect external equipment for remote alarm monitoring.
Description of the humidity sensor and its display capabilities.
Details on temperature control, setpoints, safety features, and ranges.
Technical specs for relative humidity and CO2 control systems.
Information on shelves, construction, fittings, and electrical requirements.
Overall dimensions, weight, and safety certifications for the unit.
Wiring diagrams for the 115V Steri-Cycle Heat Sterilization Incubator.
Wiring diagrams for the 230V Steri-Cycle Heat Sterilization Incubator.
To Next Page