Need help?Do you have a question about the Thermo Scientific NAPCO 8000DH Series and is the answer not in the manual?
General| Brand | Thermo Scientific |
|---|---|
| Model | NAPCO 8000DH Series |
| Category | Accessories |
| Language | English |
Guide to navigating the incubator's control panel modes and functions.
Steps for positioning the incubator, including clearance and surface requirements.
Instructions for safely stacking multiple incubator units.
Details on installing access port, HEPA, and air sample filters.
Procedures for connecting power, CO2 gas supply, and humidity pan.
Guide for setting initial temperature, overtemp, and CO2 setpoints.
Procedure for calibrating the incubator's temperature sensor.
Steps to calibrate thermal conductivity (T/C) and infrared (IR) CO2 sensors.
Method for calibrating the relative humidity sensor.
Setting low/high temperature and CO2 alarm limits and relay triggers.
Configuring HEPA filter reminders and setting an access code.
Setting low RH alarm limits and configuring Temp/RH display options.
Entering T/C CO2 sensor zero and span numbers for calibration.
Details on the 'TMP CTRL ERR' alarm and its causes.
Information on 'Sensor Fault Alarms' and troubleshooting steps.
Instructions for cleaning the incubator's interior, doors, and humidity pan.
Procedures for HEPA and air sample filter maintenance and replacement.
Detailed steps and precautions for performing the sterilization cycle.
Connecting external equipment to the incubator's alarm system.
Overview of the humidity sensor and its readout capabilities.
Technical specifications for temperature, humidity, and CO2 control.
Details on dimensions, construction, electrical requirements, and weight.
Information on safety standards, installation category, and pollution degree.
List of part numbers and descriptions for replacement components.
To Next Page