What to do if Thermo Scientific Precision Water Bath Laboratory Equipment shows Low Fluid Level?
If your Thermo Scientific laboratory equipment indicates a low fluid level, it means the low-level protection limit has been exceeded. You should check the fluid level and inspect for any leaks.
How to fix Bad Calibration error on Thermo Scientific Laboratory Equipment?
To resolve a bad calibration error on your Thermo Scientific laboratory equipment, redo the calibration. Make sure the calibration set points are at 35.0°C and 70.0°C (or 35.0°C and 55.0°C for Coliform Baths).
What to do if Thermo Scientific Laboratory Equipment displays HTC error?
If your Thermo Scientific laboratory equipment displays an HTC error, it indicates the high temp protection limit has been exceeded. Allow the bath to cool down, then restart it. If the issue persists, the bath must be serviced by an authorized Thermo Scientific Temperature Control Service Technician.
What to do if Thermo Scientific Laboratory Equipment has Open or Shorted Internal Temp Sensor?
If your Thermo Scientific laboratory equipment has an open or shorted internal temperature sensor, the bath must be serviced by an authorized Thermo Scientific Temperature Control Service Technician.
Instructions for unpacking the bath, including precautions and handling.
Information on contacting Thermo Fisher Scientific for support and service.
How to provide feedback on the user manual to Thermo Fisher Scientific.
General safety precautions and understanding of warning labels.
Overview of Thermo Scientific Precision Water Baths, features, and construction.
Technical specifications for COL 19 and COL 35 models, including temperatures, dimensions, and power.
Information on product safety standards, FCC compliance, and Canadian IC notices.
Details on REACH and RoHS compliance in Europe.
Compliance with Chinese regulations for electronic information products.
Information on CE marking and European Union directives.
Information on compliance with the EU Waste Electrical & Electronic Equipment Directive.
Guidelines for installing the bath for continuous operation and indoor use.
Information regarding ventilation requirements for the bath.
Instructions and illustration for installing the bath cover.
Details on electrical specifications, grounding, and plug types for the baths.
Lists approved fluids for Precision baths and warnings for water usage above 80°C.
Permissible and desirable levels for process fluid quality parameters.
Instructions on how to fill the bath reservoir with approved fluids.
Procedures for safely draining the bath before moving or storing.
Information on accessories supplied by Thermo Fisher.
Instructions for installing the drain kit accessory.
Overview of the digital controller, its displays, and buttons.
Step-by-step guide for initial bath startup, including power and fluid addition.
How to select and change preset temperature set points on the controller.
How the temperature is displayed on the controller and how to return to previous screens.
Procedures for safely shutting down the bath and its components.
Instructions for adjusting timer settings, audible alarm status, and high temperature alarms.
Procedure for calibrating the reservoir fluid temperature sensor.
Explanation of the low fluid protection feature and its behavior.
How to adjust the Real Time Adjustment (RTA) for temperature accuracy.
Information on the pump inlet filter and its maintenance.
Instructions for cleaning the bath surfaces, reservoir, and components.
Ensuring the replacement power cord is properly rated.
Explanation of error messages and their causes/actions.
Troubleshooting checklist for common issues like bath not starting or inadequate temperature control.
General| Brand | Thermo Scientific |
|---|---|
| Model | Precision Water Bath |
| Category | Laboratory Equipment |
| Language | English |
To Next Page