ThermoFlow Hydrex 18 - Declaration of Conformity; Standards and Regulations; Electrical Installation

DE GB
16
Children shall not play with the appliance. Cleaning and user mainte-nance shall not be made by
children without supervision.
Declaration of conformity
NEG-Novex GmbH hereby declares that the Thermoflow device complies with the direc-tives and
standards:
• 2006/95/EC Low Voltage Directive
• 2004/108/EC Electromagnetic Compatibility Directive
• 2011/65/EC (RoHS II)
• 2009/125/EC Ecodesign
• (EC) No. 814/2013 And also comply with the provisions of the following European Standards:
• EN 62233:2008 + C1:2008
• EN 50581:2012
• EN 61000-6-1:2007
• EN 61000-6-3:2007
• EN 60335-1:2012 + AII:2014
• EN 60335-2-35:2002 + C11:2006 + A1:2007 + A2:2011
22-07-2016
NEG-Novex Großhandelsgesellschaft für Elektro- und Haustechnik GmbH
Chenover Str. 5, D-67117 Limburgerhof
Standards and regulations
The installation (plumbing and electrical work), commissioning and maintenance of this appli-
ance should only be undertaken by person-nel with electrical engineering qualifications and
in accordance with the relevant standards and regulations (BSI, etc.) and this manual.
Correct and reliable operation of this unit will only be ensured if the original accessories and spare
parts are used. The following should be observed:
DIN VDE 0100: Requirements of your electricity supplier.
DIN 1988 / DIN 4109: Requirements of your water supplier.
The following should also be observed:
• the appliance name plate;
• the technical specifications.
Connection to the water supply
Compatible cold water pipe materials: steel, copper and plastic.
Operating conditions to DIN 1988, Part 2, December 1988, Section 2.2.3, Table 1. There is no need to
install a relief valve. Compatible hot water pipe materials: copper, approved plastic piping systems.
During normal operations and fault conditions, the operating conditions to DIN 1988, Part 2, Decem-
ber 1988, Section 2.2.3, Table 1 apply.
This device should be permanently connected to the water mains and cannot be connected by a
hose-set
Electrical installation
This unit may only be connected to a fixed cable.
It should be possible to isolate the device from the mains supply on all poles by fuses or other
means which provide a gap of at least 3mm!