24
© 2009 by Thermoplan AG, Subject to change
User Manual CT / CTS / CTMcool
805.012_REV-1_EN
User display messages
Display messages What?
Milk low
Milk level is low•
- Fill milk container
Defective milk level•
=> Contact service
Foamer off
Milk circuit is turned OFF•
- If needed turn Foamer ON
- Simultaneously press and hold the “Double Product” key and any “Milk” beverage key.
The display shows Foamer On
Powder error
Too much coffee is being ground and exceeds the fill capacity of the brew chamber•
1. Clear error with the „Step“ key
2. Reselect the same beverage again
3. If error message reappears check powder quantity and if needed readjust grinder
to a finer grind
Change filter
The water filter system needs maintenance. The message remains on the display •
until the water counter is reset to 0. All beverages can be produced.
=> Contact service
Service required
He machine has reached the number of programmed coffee cycles and •
a preventative service must be performed
=> Contact service
Clean appliance
The machine has reached the programmed number of coffee cycles and •
a cleaning cycle must be performed.
- Cleaning cycle must be performed
Flow error
No water supply•
1. Check
2. => Contact service
No water pressure to machine•
- Check water pressure to coffee boiler, (min 2 bar)
Voltage high
109%
Function Voltage Control active (Voltage is too high)•
- As soon as the voltage drops down to the programmed value all products can be
produced again.
Voltage low
91%
Function Voltage Control active (Voltage is too low)•
- As soon as the voltage goes up to the programmed value all products can be
produced again
To Next Page
Loading...
Need help?
General
